Things to note when replacing the automatic screw machine bit

Shenzhen Xiaomao Automation Technology Co., Ltd. is a professional supplier in the field of automation equipment. Its automatic screw locking machine is widely used in electronics, automobiles and other industries with its efficient and precise performance. In the process of using the automatic screw locking machine, the screw bit, as a part that directly contacts the screw, will wear due to long-term use or locking screws of different specifications. Therefore, regular replacement of the screw bit is the key to ensure the normal operation of the equipment and the quality of locking. The following are several things that must be paid attention to when replacing the screw bit of the automatic screw locking machine.

First, be sure to choose a screw bit that matches the screw specifications. Screws of different models and sizes require screw bits of different specifications. For example, M2 screws usually require a screw bit with a diameter of 2mm, while M3.5-M5 screws require a PH2 cross screw bit. If the screw bit does not match the screw, it will not only cause problems such as loose locking and screw slippage, but may also damage the screw bit and screw, and even affect the normal operation of the equipment. Before replacing the screw bit, be sure to carefully check the specifications of the screw and select the appropriate screw bit.

Secondly, standardize the operation when installing the screw bit. During the installation process, ensure that the screw bit is tightly connected to the spindle of the equipment to avoid loosening. You can use the tools that come with the equipment or a suitable wrench for installation. Pay attention to the installation force. It should not be too tight to damage the bit or spindle, nor too loose to cause the bit to fall off during work. At the same time, the bit should be installed in the correct direction to avoid installation errors affecting the locking effect. It is recommended to use a torque range of 0.5-1.0Nm for installation to ensure that the bit is firmly installed and will not be damaged due to overtightening.
In addition, you also need to pay attention to the replacement cycle of the bit. The replacement cycle of the bit depends on the frequency of use and the working environment. Under high-frequency use, it is recommended to check the wear of the bit after every 5000-10000 locking operations. If the bit is found to be severely worn, it should be replaced in time to avoid affecting the locking quality and equipment performance.

Finally, be sure to test after replacing the bit. First, perform a no-load test to observe whether the bit runs smoothly and whether there is any abnormal vibration or noise. Then select a small number of products for actual locking test to check whether the locking effect meets the requirements, such as whether the screws are locked and whether the locking torque is appropriate. Only when the test passes can it be ensured that the bit replacement is successful and the equipment can be put into production normally.
Xiaomao Automation reminds users to pay attention to the details of replacing the screwdriver bits of the automatic screw locking machine. Only by correctly selecting, installing and testing the bits can the equipment continue to perform efficiently and ensure smooth production. If you encounter any problems during use, please feel free to contact our technical support team. We will wholeheartedly provide you with professional services and solutions.